SIKORA Launches Its New LINE PERFORMANCE OPTIMISER Software Programme

Increasing demands on the signal and transmission quality of data cables require precise insights into manufacturing quality and sources of interference. In cable production, consistent product quality is a sign of the manufacturer’s excellence. Low process variation is a key condition for consistent quality within the required tolerances. With the LINE PERFORMANCE OPTIMISER (LPO) SIKORA presents a new software programme that detects quality fluctuations at an early stage during production. It was first unveiled to the public at wire Düsseldorf trade fair in April this year.

The standard deviation σ (sigma) of different measured values can be an important indicator of the quality of a final product. However, its value is only representative if the individual measured values are unadulterated, e.g. if they have not been averaged. This is because short-term interferences or cyclically occurring peaks are no longer present in smoothed data.

SIKORA’s new LINE PERFORMANCE OPTIMISER (LPO) software programme is based on individual values with extremely high accuracy, which are not subject to any averaging. The individual values are available in every SIKORA measuring device and are consolidated in a connected ECOCONTROL processor system. This provides a transparent overview of the quality level of the entire line. Deviations, known as noise levels, can be detected at an early stage, clearly located, and specifically remedied with the operator’s experience – for a stable process and consistently high production quality. Production quality is clearly visualised on the ECOCONTROL processor system.

The LINE PERFORMANCE OPTIMISER uses precise individual measurement values to reveal the full picture of irregularities in an extrusion process. Thus, it provides information about the source of any interference and assists in resolving the issue.

www.sikora.net